What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 01:16

These are simplified answers to the original question, and does not change anything I wrote above.
What does a fuse do?
One is “what exactly is in a ‘surge protector’ ? ”
Isaacman interested in privately funded science missions - SpaceNews
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
But… the neutral is now “floating” because of the 1 ohm resistance.
nine
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
what exactly is a ‘surge’ protector?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Tulsa, Oklahoma, plans more than $105m in reparations for America's 'hidden' massacre - BBC
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Here is a simplified AC power diagram.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
First Signal of Climate Change Became Detectable 130 Years Ago - ScienceAlert
2024–10–10[John johnson John Johnson ]
There are two important concepts here.
I post the exact comment here.
What is the best AI tool for interior design?
but I think this circuit , shows a few more pieces.
At least they know the answer if they wanted it.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Paris Baguette: The Korean bakery that wants to make croissants less French - BBC
In schematic diagrams this is the symbol for a fuse:
but this device (an Inductor) … impedes the rapid changes in the current.
What is lightning?
This Image Shows Satellite Streaks Blocking Out the Arctic Sky - PetaPixel
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Because the load is inductive, the current lags the voltage.(by a bit).
Athletics' Denzel Clarke leaps over wall to rob Angels' HR for incredible catch - ESPN
The bolt then partially travels down the line to your home.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Cancer patient given months to live is 'more positive than ever' - BBC
eight
a photo is worth a thousand words.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
US measles total nears 1,100 cases as Colorado reports airline cluster - CIDRAP
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Now when you have a certain ac resistance, then a current flows in a loop.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
The third is lightning and “how it gets conducted into a home.”
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
the problem then depends on "how fast does the fuse operate?".
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
The other is “what does a “fuse” do?”
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Upvotes:
This is where this question deviates from being a 'generic' question, and becomes more specific.
He then asserts :
It also is a device that limits the change in current flow.
He then describes the function of a fuse.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Edit 2024–10.
Barnstars:
An AC voltage/ current source, and an ac inductive load.
This device then solves the entire problem.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
[image of Common-mode choke]
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
[old diagram got deleted by accident]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
(Dc diagram shown, AC is similar).
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This is where the MOV conducts again, and dissipated the energy.
A circuit breaker is similar, but is resettable.
A fuse is a non-resetable over current circuit protector.
There are three different concepts here that are getting confused.
But it can get overloaded, and no longer works.
It seems Mohan does not understand the difference between a comment and an Answer.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
One
2024–10–16 [ OO OLAOYE OYEBODE ]
At one ohm, the resistor has a maximum of 1 watt power.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
The MOV will conduct when the voltage exceeds 50% of line voltage.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is 'the assistant's answer'
so, what happens?
These devices are installed between the “hot” and “neutral” and protective ground.
For this case there are devices called Metal oxide varistors (MOV).
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
He then describes Rainy Season and Lightning.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
First Sentence:
This one hit behind the barn.